ELISA Kit for Orexin (OX)

Our Elisa Kit products are perfect for the analysis of biological fluids, including Serum, plasma, tissue homogenates, cell lysates, cell culture supernatants, and other biological fluids.

ConductScience offers Elisa Kits for Analysis.

$885.00
Specificity

This assay has high sensitivity and excellent specificity for the detection of Orexin (OX).

No significant cross-reactivity or interference between Orexin (OX) and analogs was observed.

Recovery

Matrices listed below were spiked with a certain level of recombinant Orexin (OX). The recovery rates were calculated by comparing the measured value to the expected amount of Orexin (OX) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)94-10197
EDTA plasma(n=5)84-9690
heparin plasma(n=5)80-9890
Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle, and high-level Orexin (OX) were tested 20 times on one plate, respectively.

Inter-assay Precision (Precision between assays): 3 samples with low, middle, and high-level Orexin (OX) were tested on 3 different plates, 8 replicates in each plate.

CV(%) = SD/meanX100

Intra-Assay: CV<10%

Inter-assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Orexin (OX) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected

Sample1:21:41:81:16
serum(n=5)81-99%83-91%84-97%80-105%
EDTA plasma(n=5)82-96%79-97%83-102%98-105%
heparin plasma(n=5)78-96%85-94%84-97%78-90%
Stability

The loss rate of activity determines the stability of the kit. The loss rate of this kit is less than 5% within the expiration date under appropriate storage conditions.

To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, and incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided
ReagentsQuantityReagentsQuantity
Pre-coated, ready-to-use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1Assay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
Reagent Diluent1×300µLStop Solution1×6mL
TMB Substrate1×9mLInstruction manual1
Wash Buffer (30 × concentrates)1×20mL--
Assay procedure summary
  1. Prepare all reagents, samples, and standards;
  2. Add 50µL standard or model to each well. And then add 50µL prepared Detection Reagent A immediately.
  3. Shake and mix. Incubate for 1 hour at 37°C
  4. Aspirate and wash 3 times;
  5. Add 100µL prepared Detection Reagent B. Incubate for 30 minutes at 37°C;
  6. Aspirate and wash 5 times;
  7. Add 90µL Substrate Solution. Incubate for 10-20 minutes at 37°C;
  8. Add 50µL Stop Solution. Read at 450 nm immediately.

Additional information

Brand

Cloud Clone

gdpr-image
This website uses cookies to improve your experience. By using this website you agree to our Privacy Policy.
Read more