What does efficiency mean?

Efficiency accounts for current not used for the desired deposition reaction.

What area should I enter?

Enter the active plated area in cm2.

Does this model throwing power?

No. It assumes uniform current distribution over the entered area.

ToolsConductScience tool

ElectroplatingFree in-browser calculator

Faraday Deposition Calculator.

Estimate deposited mass and coating thickness from electroplating inputs. For materials research, education, and protocol documentation only. Not a certified inspection, compliance, asset-integrity, or final acceptance tool.

Run calculator Request a Quote

PrivateData stays in your browser

LiveNo sign-up required

Validated2026-05-24

CitableMethods and citation included

Calculator

Results update in place

Try it out

Load example faraday deposition data to see the full workflow

Faraday Deposition inputs

Current

Time

Molar mass

g/mol

Valence n

Area

cm2

Density

g/cm3

Efficiency

Results

Deposited mass

755.483 mg

Thickness

33.954 um

Charge

2700 C

Mass

755.483

Thickness

33.954

Review notes

Real plating thickness depends on geometry, agitation, bath chemistry, and current distribution.

Methods note

Uses Faraday law mass = I * t * M * efficiency / (n * F), then thickness = mass / (density * area).

Scope and limitations

For materials research, education, and protocol documentation only. Not a certified inspection, compliance, asset-integrity, or final acceptance tool.

Results are deterministic calculations from the values entered here. Review units, assumptions, and measurement quality before using outputs in reports or protocols.

Method

Uses the tool-specific formulas and assumptions shown in the calculator output.

Validated

Last validated 2026-05-24. Calculations are designed for planning and documentation support; verify procurement decisions against manufacturer specifications or institutional SOPs.

How to cite

How to Cite

Faraday Deposition Calculator (1.2.0). ConductScience, Inc. 2026. Available at: https://conductscience.com/tools/faraday-deposition-calculator

For materials research, education, and protocol documentation only. Not a certified inspection, compliance, asset-integrity, or final acceptance tool.

Frequently asked

325

Free tools

1,200+

Institutions

100%

Client-side

Uploads required